| | | Hook Up Wire for Hobby Modeling Projects | 
 |
| Kynar 28Awg Electric Wire
Choose from 25 foot or 50 foot kynar spools.
If you need a bit of connection wire to bring your power supply out to your LEDs, use this 28Awg Kynar. This Military Grade wire is easy to solder, very high quality, high conductivity for it's size, and is the same wire that we use for all of our LEDs.
Small but Mighty!
This wire has a nice slim jacket of kynar making it easy to fit into small spaces. Yet it is fully capable of handling 36 volts of power at 5 amps.
Ideally suited for many applications, this wire is OFHC (oxygen free high conductivity copper wire) and provides a very flexible and very abrasion resistant hook up wire.
The wire is single solid copper single strand, and easy to connect to other wires by either twisting or soldering.
How to strip this wire?
Kynar it has a tough outer jacket and a finer gauge than many wire strippers go down to. We thought this video would help:
|
flash player needed
|
- set out a piece of paper towel
-
heat up your solder iron, we used an ordinary 12 volt pencil style Iron
-
Cut your wires to the desired length, this leaves un-stripped ends
-
lay one wire on the paper towel holding the wire between two fingers about 3/4" above the cut end
-
Place the tip of the soldering iron 1/4" up from the end
-
Count to two seconds
-
pull the wire out from under the iron, the wire comes clean!
-
wipe the iron on the paper towel, it does not "damage" the iron in any way
-
Do the second wire
|
Thanks to Luci Hanson of Cascade Miniatures for this very helpful Video and description!
| Customers Also Purchased | | Also In This Category | |
|
