These Super Bright Slow Flashing LEDs come Fully Assembled and ready to use with your track power.
Extra wire! There is 14" of wire between the bulb and the electronic unit. 3" of wire after. This lets you put the bulb in place by pushing it up through the bottom of your water tower, radio tower, bridge abutment, building, or other structure. No need to take the roof off!
These Warning Beacon Flashing LEDs come fully pre-assembled and look great on Water Towers, Smoke Stacks and Bridges, Electrical Transmission Towers, or Radio Towers.
Colors: RED or WHITE
This is a nice slow flash rate for many warning beacon uses.
Connect these LEDs to any track power source: AC DC or DCC, or connect them to a battery or 12V wall adapter. They will work great with 7-19 Volts of Power.
If you are going to cut the wires and fish the bulb down from the top:
cut one wire short and wire one long so
you cannot mix up when putting back together
even more important, you cannot cause a short circuit even if you forget or miss-apply your shrink tube. The connections cannot physically touch each other if cut that way!
after threading the wire through your structure, make your re-connect farther away from structure. Assuming 14" wire gives you enough room. If you need more wire for bigger structures splice in some hook up wire. 25ft Spools of Kynar